 | IP67 ULTRA SEAL Lamp Leads
Replacement lamp leads for the ULTRASEAL controllers
• Available in T5 and T8 sizes
• Waterproof to IP67
• T5 Lamp Lead Length 2m
• T8 Lamp Lead Length 3m |
 |
| IP67 ULTRA SEAL Replacement Lamp Holder Rings
Replacement ULTRASEAL screw-on lamp holder rings for use with ULTRASEAL controllers
• Available in T5 and T8 sizes
• Waterproof to IP67
|
|
 | Spring Clips With Fasteners
Fluorescent tube holding spring clips, supplied in packs of two.
• Comes complete with a pair of nylon nut and bolt fasteners
• Available in T5 and T8 sizes
• Supplied in packs of 2 |
|
 | Stainless Steel Clips
Recommended for use with T5 high output lamps due to the higher heat and UV exposure
• Available in T5 only
• Supplied in packs of 2
• Comes complete with stainless steel nut and bolt fasteners |
|
 | Fluorescent Starter Switches
Replacement starter switches required for magnetically ballast controllers.
ABFSU is for use with single lamp controllers,
and ABFS2 is for 58W and twin controllers. |
|
 | Overtank Luminaire Suspension Kit
For use in cases where the Overtank luminaire is the desired form of lighting, but mounting directly onto the tank is not possible - e.g. over a triangular corner aquarium, or is not the preferred option. The Suspension Kit attaches directly to each end of the Luminaire, and allows it to be suspended from the ceiling, or from wall brackets in the same way as the 3 Series pendant range. |
|
 | Pendant Wall Brackets
As an alternative to ceiling mounting, this pair of brackets can be attached to the wall behind the aquarium, with the arms of the bracket extend out above the aquarium, and the pendant can be suspended from any one of three mounting points. |
Locate your nearest 
